Quality & Innovation
TOLL FREE   800.423.0970   |   860.666.9685

INSTALLATION AND INSTRUCTIONS

Acme Wedge Chuck Installation Instructions

The Acme Wedge Chuck is designed to retrofit easily on your machine. The unit is lubricated prior to shipment and does not require any immeadiate lubrication. Reference lubrication instructions for frequency and volume. All Acme Wedge Chuck Assemblies are designed with a holding pin system that keeps the unit closed without the use of the spool cam. We DO NOT recommend replacing the old spool cam that is on the machine when converting to Nowak Wedge Chucking. Follow these simple instructions for easy installation.

  1. Remove:
    a. Pusher tubes
    b. Spindle collects
    c. Collet tube nuts
    d. collet tubes
    e. Screw for finger holder
    f. Finger holder assemblies
     
  2. Clean all parts throughly.
     
  3. Slide Nowak Wedge Chuck Assembly on to the spindle. Replace clamp screw and torque to the same tension as with the finger holder. DO NOT USE LOCTITE THREADLOCKER OR EQUIVALENT TO RETAIN CLAMP SCREW.
     
  4. Repeat Step 3 for all spindles
     
  5. Replace:
    a. Collet tubes
    b. Collet tube nuts
    NOTE: The wedge chuck requires the use of collet tube nut only.
    c. Spindle collets
    d. Pusher tubes
     
  6. a. The Acme Wedge Chuck Assembly does require more closing face to achieve the same collet tension as the original design - finger holder assembly.
    b. Adjust the Acme Wedge Chuck Assembly according to the part application.
    CAUTION: THE WEDGE DESIGN IS A RIGID SYSTEM AND IS NOT FLEXIBLE LIKE THE FINGER HOLDER ASSEMBLY. A SLIGHT TURN OF THE COLLET TUBE NUT WILL CHANGE THE COLLET TENTION DRAMATICALLY. SEVERE DAMAGE WILL RESULT FROM OVERTIGHTENING.
    c. Explain to machine operator about adjustment and increased closing force requirements.

***DO NOT TEST RUN MACHINE WITHOUT COLLET TUBES/COLLETS***

The Parts you need to keep business moving forward

New Davenport® replacement parts

Check out our standard Davenport replacement part list!

Used & Rebuilt Davenport® parts and attachments 

Davenport Parts | Feed Gears | Spindle Gears | Turret Cams | Attachments | Cross Slide Cams

Davenport® Rebuilding 

Nowak is proud to present rebuilding choices from short blocks to complete rebuilt to turn key Davenport Model B.

Remanufactured Davenports® Model B and Machine enhancements